Medium strength thixotropic anaerobic thread locker. The product cures when confined in the absence of air between close-fitting metal surfaces.
Properties
Formulated to lock all metric and imperial nuts and bolts
Prevents vibration loosening and leakage through the threads
Slightly oil tolerant; it will bond some ‘as received’ parts, but best results are obtained with clean substrates.
The thixotropic nature of the product prevents run off, dripping and migration after assembly.
Typically used on mounting bolts, housing screws, etc.
Prevents corrosion of assembled parts.
Application Areas
Clean male and female threads before assembly with an absorbent tissue paper to remove any cutting oil.
Apply the adhesive with a 360 turn to leading threads of the male and female fittings.
Use an absorbent tissue paper to wipe off excess jointing compound in the direction of the thread.
Assembly parts and hold on for 24 hours at 22-24°C to ensure full curing of jointing compound.
For disassembly, use hand tools to remove mating parts. When it is hard to dissemble at room temperature, apply local heat until reaching 250°C and disassemble while hot. Then, remove any residual cured adhesive mechanically and clean parts with a proper solvent, acetone.